BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual, Page: 328 / 427

Section 06 ELECTRICAL
Subsection 05 (ELECTRIC STARTER)
MMR2004-133_06_05A.FM
06-05-9
1. Shorter stud
2. Bare wire
Skandic WT LC/SUV 600
Reverse the order of disassembly to reassemble
starter. However, attention should be paid to the
following operations.
Prior to assembling, coat sliding surfaces on arma-
ture shaft splines, overrunning clutch, bushing and
roller bearing with synthetic grease (P/N 413 711
500).
After placing collar no. 3 on armature shaft no. 11 ,
fit new snap ring no. 2 on armature shaft, then
make sure that it is properly secured.
Slide collar no. 3 over snap ring no. 2 and secure
in place by punching it at two or three places.
1. Armature shaft
2. Snap ring
3. Collar
4. Punch
Starter Housing Assembly and Starter
Housing
Align previously traced indexing marks.
TYPICAL
1. Aligned indexing marks
Open brushes and slide over commutator.
Align end frame locating notch with yoke locating
protrusion and properly sit brush holder
no. 13
into housing no. 14 .
1. Brush holder
To ease end frame installation, retain brush holder
with a small screwdriver while installing armature
assembly.
CAUTION: Make sure to place two end housings
on a flat surface before tightening the through
bolts.
CAUTION: Make sure end frame fits perfectly
on yoke.
A19E09A
1
2
A03E0EA
1
2
4
3
1
A32E21A
1
A32E23A