BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual, Page: 238 / 427

Section 05 TRANSMISSION
Subsection 03 (DRIVE PULLEY)
05-03-14
MMR2004_123_05_03A.FM
Sliding Half Bushing Replacement
NOTE: If the bushing is worn out, it is recom-
mended to replace the whole sliding half ass’y, as
replacing the bushing only may reduce the drive
pulley performance.
Remove circlip from the sliding half.
1. Circlip
Secure the spring compressor (P/N 529 035 524)
in a vise. Mount tool (P/N 529 031 200) and the
sliding half ass’y on it.
Use tool (P/N 529 035 931) to press out old bushing.
NOTE: Make sure to use the tool (P/N 529 035 931)
as marked; to remove the bushing press using the
side marked “OUT”, as shown below in the picture.
Use a soft sand paper to clean sliding half bushing
mounting surface.
Clean sliding half bushing mounting surface with
pulley flange cleaner (P/N 413 711 809).
To install a new bushing, secure the spring com-
pressor (P/N 529 035 524) in a vise and mount the
sliding half ass’y. Insert the bushing from inner
side of sliding half ass’y.
Mount tool (P/N 529 035 931) with side marked “IN”
to press in a new bushing.
A32D2TA
1
A32D2UA
529 031 200
529 035 524
A32D2VA
A32D2WA