BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual

Page: 341 / 427

Section 06 ELECTRICAL
Subsection 06 (TESTING PROCEDURE)
06-06-12
MMR2004-134_06_06A.FM
NOTE: Stop switches include the ignition switch, the tether cord switch and the engine cut-out switch.
It is important to take note that voltage measurements must be taken while starting the vehicle using the
manual starter.
Voltages obtained upon starting are proportional to the force applied onto the manual starter. A low voltage
is therefore normal under a low cranking force.
Perform testing in the prescribed order and replace any parts not performing according to specifications.
It is important to resume all tests when replacing a component.
If not specified, the probe connecting sequence is not important.
LIGHTING SYSTEM TESTING (Skandic WT/SWT)
PART
TEST TO BE
PERFORMED
WIRE
COLOR
RESISTANCE
Ω
VOLTAGE V
NOTE
VALUE
(ohms) MULTIMETER
SCALE
VALUE
(volts)
MULTIMETER
SCALE
Lighting
generator
coil
Power
YL and
YL/BK
0.05 - 0.6
00.0
Ω
2.5 - 7.0 00.0 VAC —
Insulation
YL and
engine
0.L
00.0
M
Ω
— — —
Ground
continuity
BK engine 00.0 - 00.5
00.0
M
Ω
— — —