Section 05
TRANSMISSION
Subsection 03
(DRIVE PULLEY)
05-03-12
MMR2004_123_05_03A.FM
5,6, Fixed and Sliding Half
CAUTION:
Do not tap on governor cup.
Screw puller into fixed half shaft about 13 mm
(1/2 in). Raise drive pulley and hold it by the sliding
half while knocking on puller head to disengage
fixed half.
1. Puller
2. Holding sliding half
NOTE:
No components marking is required be-
fore disassembling this drive pulley since it has
factory mark and arrows as indexing reference.
25,29, Slider Shoe and Governor Cup
Carefully lift governor cup until slider shoes come
at their highest position into guides.
Hold a slider shoe set then carefully lift its housing
and remove slider shoes. Proceed the same way
for other housings lifting one at a time.
1. Hold slider shoes
2. Lift one housing at a time
NOTE:
To ease disassembly, forks (P/N 529 005
500) should be used to hold slider shoes prior to
removing governor cup.
19, Spring Cover Ass’y
It is pushed by clutch spring pressure.
Use spring compressor (P/N 529 035 524).
Install support guide.
1. Support guide
A16D01A
1
2
A16D02A
1
2
WARNING
Clutch spring is very strong. Never attempt to
remove spring cover without the recommend-
ed tools.
A16B02A
529 005 500
1
A03D3EA
Summary of Contents for ski-doo Tundra Scandic 2004 Series
