Section 07
REAR SUSPENSION
Subsection 02
(TORQUE REACTION SUSPENSION)
MMR2004-135_07_02A.FM
07-02-3
7,8, Support and Front Arm Support
To remove rivets securing the supports, cut rivet
heads off using a cold chisel.
At assembly, position the rivet head toward the
outside of the assembly. Support the rivet head
against a metal block, as shown, and use a flat
head punch to secure the rivet in place.
1. Flat head punch
2. Support
3. Runner
4. Metal block
NOTE:
Rivets can be substituted with 3/16 in x 3/4 in
long screws and flanged elastic stop nuts. Always
position screw head outside the assembly.
INSPECTION
6, Stopper Strap
Inspect strap for wear or cracks, bolt and nut for
tightness. If loose, inspect hole for deformation.
Replace as required.
Shock Absorber
Refer to SUSPENSION AND SKI SYSTEM for shock
inspection.
11, Slider Shoe
Molding line is the wear limit indicator.
TYPICAL
1. Slider shoe
2. Molding line (wear limit indicator)
Replace slider shoes when wear limit is reached.
CAUTION:
Slider shoes must always be replaced
in pairs.
SUSPENSION ASS’Y
INSTALLATION
Release rear spring tension then install assembled
suspension into track with front portion first.
Insert rear portion of suspension into track.
Bolt suspension to tunnel.
Pry rear spring end onto cam.
1. Spring end
Adjust track tension/alignment. Refer to TRACK.
A07F02A
1
3
4
2
1
A03F3SA
2
A05F0JA
1
Summary of Contents for ski-doo Tundra Scandic 2004 Series
