BOMBARDIER ski-doo Tundra Scandic 2004 Series, Shop Manual

Page: 141 / 427

Section 04 ENGINE
Subsection 03 (443 AND 552 ENGINE TYPES)
04-03-20
MMR2004-112_04_03A.FM
Slide in the heated outer PTO bearing onto the
crankshaft.
Install the MAG side heated bearing.
All Models
Bearings are pressed on crankshaft until they rest
against radius. These radius maintain the gap
needed for bearings lubrication.
When installing crankshaft, position drive pins
no. 6 as illustrated.
TYPICAL
1. Drive pins
Skandic WT/SWT/SUV 552 Engine Type
CAUTION: Use only the recommended Isoflex
grease (P/N 293 550 021). Make sure not to push
Isoflex grease between outside bearing race and
half crankcase.
NOTE: The 50 g tube corresponds to 50 cc of grease.
Put 27 to 32 mL of grease in a syringe.
With the syringe, fill the PTO side ball bearings with
27 to 32 mL of Isoflex grease as shown below.
A32CBEA
A32CBFA
A03C1HA
1
A32CBGA