
Section 05
TRANSMISSION
Subsection 03
(DRIVE PULLEY)
MMR2004_123_05_03A.FM
05-03-19
1. Position 1 (not numbered)
Each number modifies maximum engine RPM by
about 200 RPM.
Lower numbers decrease engine RPM in steps of
200 RPM and higher numbers increase it in steps
of 200 RPM.
Example:
Calibration screw is set at position 3 and is changed
to position 5. So maximum engine RPM is increased
by about 400 RPM.
To Adjust:
Just loosen locking nut enough to pull calibration
screw
partially
out and adjust to desired position.
Do not completely remove the locking nut. Torque
locking nuts to 10 N•m (89 lbf•
in
).
CAUTION:
Do not completely remove calibra-
tion screw otherwise its inside washer will fall
off.
CAUTION:
Always adjust all 3 calibration screws
and make sure they are all set at the same num-
ber.
1. Loosen just enough to permit rotating of calibration screw
A16D0GA
1
A16D0HA
1
Summary of Contents for ski-doo Tundra Scandic 2004 Series
