Section 05
TRANSMISSION
Subsection 03
(DRIVE PULLEY)
05-03-8
MMR2004_123_05_03A.FM
Heat spider
no. 5
to melt threadlocker.
Install spider tool (P/N 529 025 200) then, unscrew
spider
no. 5
.
1. Spider wrench
Note shim
no. 8
quantity.
1. Shims
Remove cam arms
no. 12
.
CLEANING
Clean pulley faces and shaft with fine steel wool
and clean dry cloth. Clean sliding half bushing
no. 9
and cover bushing with clean dry cloth.
Thoroughly clean spider threads and fixed half
post threads.
INSPECTION
Check sliding half for excessive lateral play and
fixed half post for scratches. Replace as required.
Check cover bushing interior. Replace cover if
bushing is completely bronze instead of the origi-
nal teflon coating.
Check spider thrust buttons
no. 6
for proper sliding
action. Replace as required.
Check rollers
no. 7
for free action. Replace as re-
quired.
ASSEMBLY
Install shims
no. 8
on fixed half post.
Apply Primer N (P/N 293 800 041) to both post and
spider threads, allow to dry for 10 minutes. Apply
Loctite 271 (P/N 293 800 005) to threads.
Using spider wrench from tool kit (P/N 529 025
400) torque spider
no. 5
to 170 N•m (125 lbf•ft).
With square end facing sliding half, install a washer
no. 13
on each side of cam arm
no. 12
.
1. Square end facing sliding half
Tighten to 5.6 N•m (50 lbf•
in
) maximum all three
pivot nuts
no. 15
. Make sure cam arms
no. 12
can
still move on their pivot bolts
no. 11
.
1
A29D26A
1
A29D27A
1
A29D28A
A29D29A
Summary of Contents for ski-doo Tundra Scandic 2004 Series
