Section 07
REAR SUSPENSION
Subsection 02
(TORQUE REACTION SUSPENSION)
07-02-2
MMR2004-135_07_02A.FM
COMPONENT REMOVAL
Lift rear of vehicle and support it off the ground.
5, Rear Arm
Release track tension.
Release spring tension. Unfasten shock from rear
arm. Remove 3 screws retaining rear arm.
SUSPENSION ASS’Y REMOVAL
Release track tension.
NOTE:
To prevent cross shaft from turning when
unscrewing screws assembled with threadlocker,
proceed as follows:
– Loosen one screw then retighten.
– Remove the other screw.
– Remove the first one.
1,2,3,4, Cross Shaft, Idler Wheel, Spacer
and Screw
Remove idler wheel ass’y.
Suspension Ass’y
Lift rear of vehicle and support it off the ground.
Unscrew 4 screws retaining front arm and rear arm
to frame.
Remove suspension.
DISASSEMBLY AND ASSEMBLY
6, Stopper Strap
When assembling make sure it is attached through
the 3
rd
hole from the end. Torque nut to 11 N•m
(97 lbf•
in
).
1. 1
st
hole
2. 3
rd
hole
A. 11 N•m (97 lbf•
in
)
9,10,12, Nut, Slotted Screw and Slider
Shoe
To replace a worn shoe, remove the front screw
and stop nut, then slide the shoe rearward out of
the runner.
1. Front screw and nut
CAUTION:
Slider shoes must always be replaced
in pairs.
A05F0CA
A
1
2
A05F0IC
1
Summary of Contents for ski-doo Tundra Scandic 2004 Series
