Bernette Moscow 2, Instruction Manual

Page: 116 / 139

114
GB
This foot is available as special accessorie.
This foot is used to insert invisible zippers
so that they are covered by the seam, and
thus hidden. Attach the invisible zipper
foot to the machine. Adjust needle center
position and straight stitch. Stitch length
depends from the fabric. Adjust 1,0 - 3,0
mm. Place open zipper face - down on
right side of fabric as shown in picture 1.
Place the fabric edge at the 5/8 inch
marking line on the needle plate surface.
Place the zipper 1/4 inch below raw edge
of garment.
With right-hand groove of foot over coil,
stitch zipper until the foot hits the slider.
Remove the garment from the machine.
To attach the other half of the zipper, place
the fabric edge on the 5/8 inch marking
line on the needle plate as shown in
picture 2. With the left-hand groove of
foot over coil, stitch zipper until the foot
hits the slider.
Close zipper. Fold the fabric that the zipper
is on ride - hand side out of the way as
shown in picture 2.
Use a pin for fixing the fabric. Change to
regular sewing foot and saw as close as
possible with straight stitch against the
zipper.
At last carry out tie off with some forward
and reverse stitches.
Please note:
No “S” marking is shown on the stitch
length dial by model
-OSCOW .
Invisible zipper foot EN
E55-E82e_EN_DE_TR_EL_310309:07_55-90e_EN_ES_FR_PT.qxd 31.3.2009 14:36 Seite 114