Infinity WF Operator Manual
Page 116 of
117
S008459 Rev C
WF 36…
One Transport Wing must be placed between six and seven inches to the left of the center
position of the scan table, and one between six and seven inches to the right of the center
position of the scan table (see Figure A2 below)
Figure A2 – Insert position of the Transport Wings
WF 42 and WF 48…
Two transport wings must be placed between 11 and 13 inches to the left of the scan table’s
center position, one transport wing directly in the center position, and two transport wings 11
and 13 inches to the right of the scan table’s center position (see Figure A3 below)
Figure A3: Left
Center
Right
Each transport wing has two insert sides; short and long (
Figure A1
)
2. Following the position instructions directly above, insert the short side at the front of the
guide plate (adjacent to the scan table) by holding the transport wing in one hand. Pinch the
sides together slightly, making an arch. This is necessary so that the short side of the
transport wing fits into the slot