Baumuller b maXX 5000, Instruction Handbook Manual

Page: 107 / 330

107
of 328
Instruction handbook b maXX 5000
Document No.: 5.09021.16
6
M
OUNTING
The device is intended for mounting in a control cabinet.
Mounting comprises the following steps:
1 Mounting preparation

(for drilling holes/cutting out sections, see Z Drilling pattern – as from page 111)


only with active mains rectifier to operate within C2 surrounding,

for drilling holes of toroidal cores, see Z Drilling pattern toroidal cores – on page 119

2 Mounting

the device (for fixing, see Z Mounting instructions – on page 113)


possibly mounting toroidal cores

(see Z Mounting the toroidal cores – as from page 120)
6.1 Safety notes
NOTE!
Mounting shall only be performed by employees of the manufacturer or by other qual-
ified personnel.
Qualified personnel are persons who – on account of their occupational training, ex-
perience, instruction and knowledge of relevant standards and stipulations, accident
prevention regulations and operating conditions – are authorized by the persons re-
sponsible for the safety of the facilities to perform the respective activities that are
necessary, while at the same time recognizing and preventing any potential risks.
The qualifications necessary for working with the device are, for example:
m Occupational training or instruction in accordance with the standards of safety en-
gineering for the care and use of appropriate safety equipment.