Baumuller b maXX 5000, Instruction Handbook Manual

Page: 216 / 330

Fieldbus communication
Instruction handbook b maXX 5000
Document No.: 5.09021.16 Baumüller Nürnberg GmbH
216
of 328
8.4
n Please, observe an EMC-compatible laying of the Ethernet connection cables!
n The following cables were released for use by Baumüller:

Ethernet connection cable;

Further information see Z EtherCAT
®
, VARAN, POWERLINK
®
cable – on page 249.
Commissioning . The following preconditions must be fulfilled before commissioning:
1 b maXX 5000 with VARAN is installed correctly.
n Ethernet connection cables are wired correctly.
2 The control cabinet is properly locked and all safety devices are operating.
3 The b maXX 5000 device is ready-to-use.
4 Create a Lasal-Class2 project using the driver classes for b maXX 5000 drives for cy-
clic and service data communication.
5 Start the VARAN control
Address switch By means of the address switches S1 to S4 the IP-address is set

(Refer to settings Z Setting the IP address with address switches – as from page 100).
Parameters The parameter settings determine the behavior of the VARAN slave in operation. Param-
eters are set with the software ProDrive.
1 Start ProDrive
2 Click on „Project Tree“.
3 Communication settings with ProDrive
n Project Tree: Configuration/Fieldbus slave

(refer also Parameter manual b maXX 5000 )
m set Synchronization to „On“
m set Fieldbus cycle time according VARAN cycle time (1 ms, 2 ms, 4 ms or 8 ms)
m set source sync signal to fieldbus