77
Please note:
The tape must not be wound past the horizontal markers shown in the second image in section
7.1.2 These markers are used by the float
unit’s
opto sensors as a parking position once the
notes have been removed. If the tape is wound to far then the float unit needs to be returned to
innovative for repair.
7.1.4 NV11 BNV Reset procedure
To reset the note acceptors BNV code remove the acceptor as described in section 7.1.1
remove the float unit form the top of the acceptor by unclipping the retaining clips from both
sides of the acceptor.
Select the red configuration button on the main unit and hold in position. Turn on the machines
power and then release the button after 5 seconds. The acceptors bezel will now strobe and the
unit will reset.
Reconnect the float units and then refit into the machine. The BNV key will now be set to the
factory setting. Before setting the key check the interface setting is still CCtalk by double
clicking the red configuration button.
The bezel should flash 6 times. If not then hold the configuration button for 5 seconds until the
bezel lights up the release the configuration button. The NV11 will now reset. Double click the
red configuration button and ensure that the bezel flashes 6 times.
To set up the note acceptor device see section 6.5 for instructions.
