17
3.4
INFILL PANEL INSTALLATION
The instructions in this section are intended as a guide to fitting infill units to adjoining Triple 7
cabinets and must be followed correctly. Failure to do so may result in the assembly becoming
unstable and could possibly result in the cabinets toppling over.
The Infill Panel installation kit consists of the following parts
1) 1 x Infill Panel
2) 4 x Securing Brackets
3) 12 x M6 Bolts
Barcrest recommends the minimum of two people for the installation of the Triple 7 infill unit.
1. Ensure the 240V mains supply is disconnected from the cabinet before commencing infill
installation.
2. Attach one of the securing brackets to the bottom LHS of the Triple 7 cabinet by using two of
the M6 bolts supplied, as shown in the image opposite. Once the bracket is attached,
position the machine into place.
3. Attach two of the securing brackets to the top of the Infill unit by using four of the M6 bolts
supplied. As shown in the image below.
