19
3.5
TOP BOX AND INFILL POWER SUPPLY FITTING INSTRUCTIONS
These instructions are intended as a guide to fitting a 12V power supply kit to MPU6 Triple 7
machines. This kit should only be used for machines that have
infill’s
and top boxes fitted only.
1. Switch off the machines and ensure that the power supply leads are all disconnected.
2. If the infill panels have not been installed, then please refer to the fitting instructions in
Section 3.4.
3. For each machine open up the top and bottom doors to gain access to the inside of the
machine and then disconnect the main Barbus lead from the Barbus interface PCB as
shown in the first image below.
4. Locate the Barbus power extension link from the kit and connect the machines Barbus
connector to the PSU extension leads inline pins taking care that it is connected correctly as
shown in the second image below.
Barbus
power
extension
link
Existing
Barbus
lead
