3. Getting started
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
_____________________________________________________
3-63
2 - DirectColor
(read/write visual)
Enter the Visual Class [1]: 1
IP address for engine 2 [192.168.1.2]:
Ethernet address for engine 2 [00.00.00.00.00.00]: 00.a0.c0.83.54.77
Screen arrangement for engine 2 (Width x Height) [2x4]: 2x2
Position for engine 2 (X,Y) [0,0]: 2,0
Graphic card type for engine 2
1 - "AGX-3000"
2 – "AGX-3281"
Enter the graphic card type [1]: 2
Configuring the Depth Resolution (Bit Per Pixel)
–----------------------------------------------
1 - for 8 bpp (256 colors)
2 - for 16 bpp (64K colors)
3 - for 32 bpp (16M colors)
Enter the Depth Resolution [3]:
2
Configuring the Visual Class
–--------------------------
A visual class describes the characteristics of a virtual colormap,
that has been or can be created for use a particular screen
The following visual class are supported.
1 - TrueColor
(read only visual)
2 - DirectColor
(read/write visual)
Enter the Visual Class [1]: 2
These are your MLS Server settings
==================================
- Core machine's second IP: 192.168.1.254
- Engines Netmask Address: 255.255.255.0
- Operational mode : Contiguous
- Number engines : 2
- Values for engine 1: IP = 192.168.1.1 Ether = 00.a0.c0.83.76.98
arrangement = 2x2 position = 0,0
AGX-3281: Bpp = 16 Visual = TrueColor
- Values for engine 2: IP = 192.168.1.2 Ether = 00.a0.c0.83.54.77
arrangement = 2x2 position = 2,0
AGX-3281: Bpp = 16 Visual = DirectColor
Everything correct? (yes/no)? [yes]:
Finishing the configuration
After specifying the parameters for multiple logical screens the values explained in section
3.4.3 Configuring a distributed system
must be indicated.
****************************************************************
MLS X Server setup done... Have fun!
NOTE: enter "service mmtserv"
to start the EOS Distributed X Server
****************************************************************
When configuration is completed, you can enter
service mmtserv
to start the X server:
eos:/opt/MMT2686/config #
service mmtserv
If you operate TransForm A in eXtended safety boot mode, please take care to update the
backup partition after successful configuration, see section
4.8.5 Backup and restore procedures
.
