Barco TransForm A series, User Manual

Page: 22 / 198

3. Getting started
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
______________________________________________________
3-4
The back
P
ROCESSOR
with standard power supply (left) and detail of a P
ROCESSOR
with redundant power supply (right):
25
18 19 20
29 28 26 27 30 31 32 33 34
14 21-24 15 16 17 14 14
35 35 35 36 36
25 25 14
14 air supply
15 genlock loop through in (optional, required for OmniBus configuration)
16 remote power on/off connector / genlock loop through out (opt., requ. for OmniBus conf.)
17 external genlock in (optional, required for OmniBus configuration)
model AGS-3328-2/3 model AGS-3389-0/-1
18 COM2 PCIe ×16 extension cards
19 PCI extension cards … PCIe ×1 extension cards
20 PCI extension cards … COM2
21-24 PCI extension cards like network cards, link interface card, Barco’s expansion cards etc. (depend-
ing on configuration)
25 mains connection of power module
26 PS/2 mouse (green jack)
27 PS/2 keyboard (purple jack)
28 2×USB
29 COM1
30 LPT1
31 onboard VGA adapter
32 onboard LAN adapter with the following LED signals:
left LED lightens green a connection exists
blinking green activity
right LED off 10 Mbps connection
lightens green 100 Mbps connection
lightens yellow 1000 Mbps connection
33 2×USB
34 audio, micro
35 power switch of power module
36 green LED: individual power module operating
Figure 3-5
rear view of the P
ROCESSOR
with standard power supply (left) and detail with redundant power supply (right)
On the left hand side is the mains connection [25]. At the case of a P
ROCESSOR
with redundant power supplies
there is for both of the two power modules a mains connection [25] and additionally a power switch [35] and
an LED [36] that indicates operation of the power module when lightened. In the middle of the power modules
there is the air supply [14].