3. Getting started
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
_____________________________________________________
3-48
The section
Adaptor 1
treats the network options of the LAN connection of T
RANS
F
ORM
A.
You can change them by
selecting and editing them. If you are putting T
RANS
F
ORM
A into operation you have to change the pre-adjusted IP
address to your own.
Figure 3-56
Take care to insert the same sub net IP address in the configuration for a distributed system
as explained in section
3.4.3 Configuring a distributed system
The section Adaptor 2 treats the network options of the subnet, used with the distributed
system.
For the sub-net network card of the central unit, IP addresses must be specified.
Use the IP addresses
192.168.60.xxx
as long as it will not collide with any other subnet within the Internet.
Select
192.168.60.254
for the central processor.
This enables the numbering of the rendering machines
consequently with
1
,
2
,
3
, etc. Clarify the corresponding Netmask addresses with your network administrator. In
the field
Primary name + domain
insert
eos-core
.
Figure 3-57
Confirm your changes with
Accept
or leave with
Cancel
.
