4. Operating
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
_____________________________________________________
4-25
Encoder Control
This section contains data that is used, if initial communication with the encoder is
needed to prompt the encoder to send a stream. All fields must be filled in!
IP Address
IP address of the encoder; may only be filled in if
TCP
has been selected for
IP Protocol
Port
Port where the encoder listens to TCP start commands; may only be filled in if
TCP
has
been selected for
IP Protocol
IP Protocol
Should remain
udp
, as indicated in the section
Decoder control
above. Only if a commu-
nication with the encoder is required,
tcp
should be selected.
Startstring
String that is sent to the specified encoder
Figure 4-7
Parameters on the SVC Stream Params Editor
As unicast streams are only sent to one single IP address, only one Streaming Video Card at
a time is able to display one particular unicast stream.
The following table lists the encoder specific values that must be entered into the
Streams Params Editor
. They
are valid with S
TREAMING
V
IDEO
C
ARD
with firmware 4.1.3.5.
Encoder
manufacturer – type
compression
algorythm
IP
protocol
Skip bytes
at start
Skip bytes
at end
Stream
protocol
TCP
PID
AXIS – 241Q
mjpeg
UDP
0
0
auto
ON
0
use port 80 for TCP and indicate the encoder IP address,
Startstring example:
Axis241Q://GET /axis-cgi/mjpg/
ª
video.cgi?camera=1 HTTP/1.0\n\n
Signaling method is http, signaling is supported.
A maximum use of 4 4CIF streams with a maximum quality of 75% (or at
least 25% compression) is recommended.
h263
RTP
0
0
auto
OFF
0
BOSCH – Videojet 10 / Video-
jet 1000 / Videojet Xpro /
VideoJet8008 / VIP 10 /
VIP 1000 / VIP X1 / VIP X2
No on-board RCP+ support; I-frame distance may not be 0.
mpeg2
RTP
4
0
auto
OFF
0
BOSCH – Videojet 1000 / Video-
jet 8000 / Videojet Xpro /
VIP 1000
No on-board RCP+ support.
Coretec – VCX-2400-E
mpeg2
UDP
0
0
auto
OFF
0
Cornet –
iVDO Streamer 2/4 Encoder
mpeg2
UDP
0
0
auto
OFF
0
Cornet –
iVDO Streamer 2/4 Encoder
mpeg4
RTP
0
0
auto
OFF
0
DVTeL – 7601e
mpeg4
RTP
0
0
auto
ON
0
Use port 3000 for TCP,
Startstring example:
SmartSight
Exterity – A/V server
mpeg2
RTP/UDP 0 (4)
0
auto
OFF
0
IP protocol:
for Transport/UDP = UDP
for Transport/RTP and Elementary = RTP
SkipAtStart: for Elementary = 4, else = 0
Fast Video Security – ENC 8M2
mpeg2
RTP
4
0
auto
OFF
0
iMPath – i1000
mpeg2
UDP
0
0
auto
OFF
0
iMPath – i4000
mpeg2
RTP/UDP 0
0
auto
OFF
0
RTP or UDP has to be configured in accordance with the encoder configuration.
