Barco TransForm A series, User Manual

Page: 169 / 198

6. Advanced configuration
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
_____________________________________________________
6-19
6.1.9 BIOS settings for Wake On LAN
In a distributed system that is delivered with X server release 3.48 or newer, the BIOS of the mainboards of the
rendering processors is already configured to enable Wake On LAN (WOL). If you want to check the settings or if
it is necessary to enable WOL for another reason (e.g. if you want to use the onboard LAN adapter and to remove
the rendering network cards with Etherboot mechanism, please refer to section
3.2.12 Network ) you can do the
following provided that you have a model of a P
ROCESSOR
with order number
EOS-3026-5
,
EOS-3327-2
or
AGS-3328-2
or
higher:
•
Switch off the complete T
RANS
F
ORM
A system, please refer to section 3.3.3 Switching off , but leave the power
switch [35] of the rendering processor on.
Repeat the following for all rendering processors:
•
Connect a keyboard to the rendering processor
•
Switch on this rendering processor by its power button [13] at the front.
•
The device starts booting. On one channel of the display wall its graphical output is displayed. As soon as the
system offers to enter the BIOS, press the F2 -key.
•
In the BIOS take care that the following settings are selected:
Power
Power On/Off
LAN : Enabled
Power Failure Recovery : Previous State
•
If using the onboard LAN adapter, check that its use is enabled in the BIOS.
Peripheral Configuration
LAN Controller Enabled
•
Save the BIOS settings and exit the BIOS.
•
Switch off the device by its power button [13] at the front.
•
Disconnect the keyboard
After configuring all rendering processors, you can switch on the whole system again, please refer to section 3.3.2
Switching on .