3. Getting started
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
_____________________________________________________
3-17
Depending on the configuration the card is delivered with different adapter cables:
•
Dual-DVI to 2xDVI-D adapter cable:
Digital output for display on projection modules with digital input.
Figure 3-21
Dual-DVI to 2xDVI-D adapter cable
•
Dual-DVI to 2xCRT adapter cable:
Analog output for display on projection modules with analog input.
Figure 3-22
Dual-DVI to 2xCRT adapter cable
Order
The first graphic card in respect to PCI slot numbering identifies itself as primary graphic adapter by lighting the
green LED of the respective graphic channel when T
RANS
F
ORM
A is switched on. The primary graphic adapter is the
channel, where the system emits diagnostic and status messages during system startup.
•
In an OmniBus configuration
the graphic cards are plugged into the O
MNI
B
US
devices. For the explicit order
of the graphic cards, please refer to the sections
•
In a Processor configuration
graphic cards are in most cases plugged in the
P
ROCESSOR
. If multiple graphic
cards are used the other graphic cards should be inserted in sequence to the primary graphic adapter into the
PCI slots and are numbered consequently following their numbering. Please refer also to section
Each UGX
G
RAPHIC
C
ARD
provides four ports for connecting projection cubes, monitors or projectors. The upper con-
nector contains
port 0
and
1
, the lower one contains
port 2
and
3
. Thus the sequence of the graphic channels is:
board
1
2
3
port
0
1
2
3
0
1
2
3
0
1
2
3
channel
1
2
3
4
5
6
7
8
9
10
11
12
Figure 3-23
For non default sequence see section
6.1.6 Advanced configuration of TransForm A
.
