4. Operating
Barco – TransForm A - X Terminal – DOC-3265-2 – user's manual – Revision 09 – September-2006
_____________________________________________________
4-27
Encoder
manufacturer – type
compression
algorythm
IP
protocol
Skip bytes
at start
Skip bytes
at end
Stream
protocol
TCP
PID
Startstring example:
SmartSight
Only with encoder firmware 3.20 build 444. Usage of S1700e recommend.
Verint – S1700e
mpeg4
RTP
0
0
auto
ON
0
startstring example:
SmartSight
VideoLAN – VideoLAN (VLC/VLS)
mpeg2
mpeg4
mjpeg
–
0
0
auto
OFF
–
For IP protocol multicast, unicast, UDP or RTP is possible.
Visiowave – Evolution
2D wavelet
UDP
0
0
auto
ON
0
Use the encoder TCP port for TCP,
Startstring example:
Evolution
Signaling method is TCP, signaling is supported.
Visiowave – Visiobox
2D wavelet
UDP
0
0
auto
ON
0
Startstring example:
Visiobox
Encoder firmware 2.2.4 currently not supported, in case you want to use it
please contact the Barco support
Vorx – VON v1.0
mpeg2
UDP
0
0
auto
OFF
0
Decoding of AES streams is not supported.
Table 4-9
Encoder dependant parameter values
For some encoders the settings are not defined, if there are difficulties to set them, please
contact the Barco support, see section
