Barco S3 series, User Manual

Page: 145 / 538

6. EM GUI orientation
Image 6-30
Cabling between an E2 unit and an S3-4K unit
Event Master Con fi guration for an E2 and an S3–4K
1. Start the Event Master Toolset version 3.2 or higher.
2. Make sure that both the E2 and the S3–4K are discovered on the network and that they have different Unit IDs.
3. Drop the E2 in the GUI.
4. Then drop the S3–4K in the GUI.
You will be presented the option to add as a new system, add as a master, or add as a slave. An S3–4K can be added as a
Master or Slave to an E2.
5. Select either add as a master or add as a slave.
6. (Optional) At this point it is suggested that you select and name appropriately each E2 so that you can identify it in your setup.
How to Link an E2 Unit to an EX Unit or to Two Daisy-Chained EX Units
Each E2 comes equipped with two Link cards, always located in slots 1 and 2. Link cards are identi fi ed by a yellow stripe at the top.
Each EX has two Link sockets. Make sure to use the locking mechanism and then push each cable until it locks in place.
To link an E2 to an EX, connect the Link cables provided with each unit between the Link connectors as follows:
• E2 VP ID 0, Link Card slot 1, Link 1 >> EX VP ID 1, Link 2
• EX VP ID 1, Link 1 >> EX VP ID 2, Link 2
See image 6-31 for an example of the cabling between an E2 unit and two EX units.
R5905948 EVENT MASTER DEVICES 17/07/2017 141