Barco S3 series, User Manual

Page: 139 / 538

6. EM GUI orientation
HDMI Connector submenu
HDMI Connector submenu
• Color/Sample/Bit: Choices are:
– RGB/4:4:4/8 – YCbCr/4:4:4/8
– RGB/4:4:4/10 – YCbCr/4:4:4/10
– RGB/4:4:4/12 – YCbCr/4:4:4/12
– YCbCr/4:2:2/12
• Color Range: Choices are:
- RGB, Reduced Range (Values 16–235, television and
movies)
- RGB, Full Range (Values 0–255, computer monitors)
- SMPTE, Full Range
- SMPTE, Reduced Range
• HDCP Mode: HDCP Mode enables the HDCP setting for
the selected output. The default for HDMI outputs is Off.
To turn On the HDCP Mode, click on the empty checkbox.
When the checkbox displays a check mark, HDCP Mode is
On. HDCP Mode is not applicable to SDI outputs.
• Connector Capacity: If the connector is not assigned to a
destination as above the capacity can be changed. Once
included in a Destination con
fi guration this needs to be
managed thru the Adjust pane of the Destination.
SDI Connector submenu
SDI Connector submenu
• SDI Type (available with SDI connector type) : allows a
choice between HD (1.5Gb), 3G (3Gb), Level A, Level B,
Level A 2SI, or Level B 2SI.
The SDI Type options vary, depending on the format of the
Outputs. For example, for:
-
NTSC/PAL—the SDI Type can be only SD.
- 1080i or 1080p, with a refresh rate less than or equal to
30 Hz—the SDI Type can be only HD.
- 1080p, with a refresh rate greater than 30 Hz—the SDI
Type can be:
o
Level A (default)
o
Level B
o
Level A 2SI
o
Level B 2SI
The 2SI options are available only if the Input/Output con-
fi guration has 4 SDI connectors from the same card, and
the Output format is either 1920 x 1080 or 2048 x 1080.
• Color/Sample/Bit: Adjusts the color space (YCbCr),
sampling rate (4:2:2) and bit depth (10) of the output signal.
• Connector Capacity: If the connector is not assigned to a
destination as above the capacity can be changed. Once
included in a Destination con
fi guration this needs to be
managed thru the Adjust pane of the Destination.
Wide (screen) menu
In this menu, the user can adjust the data-doubling and feathering parameters necessary to setup a wide blended screen. These
actions can be performed simultaneously on all screens by clicking the “Select All” button. The data-doubling parameters can be
adjusted in either Basic Mode or Expert Mode.
R5905948 EVENT MASTER DEVICES 17/07/2017 135