Baker Hughes Druck DPI 610 IS, Instruction Manual

Page: 32 / 76

Copyright 2007 Baker Hughes Company.
22 | DPI 610/615 IS Instruction Manual–English
Chapter 5. Advanced Task
Note: PROCESS functions are not available to the output channel.
A summary of the process functions follows:
Following selection of ADVANCED from the task menu, press the INPUT key. Use the up

or
down

cursor keys to select the required input. Press the PROCESS (F1) key and use the
left

or
right

cursor keys to enable the process on/off:
Press ENTER to switch the process ON with existing settings or F1 to change process settings
(where applicable).
5.4.1 Tare Process Function
To set-up a Tare function, enable TARE from the process menu and press F1 to enter the Tare
SETTINGS functions.
Disable TARE by entering process menu and turning the function OFF .
Note: Last TARE setting is retained and will be applied when function is next enabled.
5.4.1.1 Tare Current input Reading
To tare-off the current display reading, proceed as follows:
5.4.1.2 Tare Off An Entered Value
To tare-off an entered value current, proceed as follows:
Table 5 - 1: Process Functions
Process Description
Tare Allows either the current display value or a manually entered
value to be tared off display parameter reading.
Max/Min Displays running Max/Min and present display values
simultaneously. Resettable via F1 key.
Filter Applies low pass filter function to displayed parameter. Filter
characteristics “Settling time and Band” are user programmable.
Flow Applies square root function to displayed parameter.
% Span Converts displayed parameter reading to a percentage of span.
Span definable via the F1 key.
SELECT PROCESS
ENABLE PROCESS
PROCESS UNITS SETTINGS
SELECT INPUT INPUT PROCESS
PRESSURE INT
PRESSURE EXT
VOLTAGE
CURRENT
SWITCH TEST
TARE ON
MAX/MIN OFF
FILTER OFF
FLOW OFF
%SPAN OFF
TASK : ADVANCED
SNAPSHOT MODE
VOLTAGE
PRESSURE INT
MAKE READING
ZERO
TARE OFF
A VALUE
TASK : ADVANCED
SNAPSHOT MODE
VOLTAGE
PRESSURE INT
SETTINGS