Baker Hughes Druck DPI 610 IS, Instruction Manual

Page: 34 / 76

Copyright 2007 Baker Hughes Company.
24 | DPI 610/615 IS Instruction Manual–English
Chapter 5. Advanced Task
5.4.4 Flow Process Function
To apply the flow function to a selected input, enable FLOW from the process menu and press
ENTER . The square root symbol is displayed beside the input value to indicate that the FLOW
function is active:
To cancel FLOW , press INPUT and turn function OFF at the process menu.
5.4.5 % Span Process Function
To convert a selected input display from a numerical value to a percentage of full-scale reading,
enable SPAN from the process menu and press F1 (SETTINGS) to provide access to the span
definition parameters. Two span definitions are required, Zero and Full Scale .
To leave span at current setting, press EXIT .
To define zero and full-scale settings, proceed as follows.
To cancel %SPAN , press INPUT and turn function OFF at the process menu.
5.5 Select Output
To display an output channel, select ADVANCED mode from the task menu. The display shows
the list of output selections and, if available, the UNITS soft box (F2).
The following procedure shows the method of output channel selection from two pages of options.
The second page can be obtained directly from the first by pressing the
right

cursor key:
Note:
Left/right arrow keys function as page up/down keys.
To change the output units ( pressure channels only), select the channel with the cursor keys and
press F2 before pressing ENTER .
TASK : ADVANCED
SNAPSHOT MODE
VOLTAGE
PRESSURE INT
SET SPAN
SET SPAN
SELECT VALUE
SELECT VALUE
CHANGE
VALUE
PRESENT
READING
CHANGE
VALUE
PRESENT
READING
ENTER A VALUE OR
PRESS F2 TO SELECT
PRESENT READING. EXIT
TO QUIT WITHOUT CHANGE ENTER A VALUE OR
PRESS F2 TO SELECT
PRESENT READING. EXIT
TO QUIT WITHOUT CHANGE
DISPLAY VALUE DISPLAY VALUE
SELECT OUTPUT
UNITS
SELECT OUTPUT
PRESSURE INT
PRESSURE EXT
mA STEP
mA RAMP
mA VALUE
SELECT OUTPUT
NO OUTPUT