Baker Hughes Druck DPI 610 IS, Instruction Manual

Page: 47 / 76

Copyright 2007 Baker Hughes Company.
English–DPI 610/615 IS Instruction Manual | 37
Settings - Select Setup Option
7.4.4 RS232
Select RS232 from the SETTINGS menu and proceed as follows:
Note: Default settings are shown above. If a communications problem occurs at a particular baud
rate, change the baud rate on the instrument and the PC to a lower rate.
7.4.5 Powerdown
Select POWERDOWN from the SETTINGS menu and proceed as follows:
If selected to TIMER mode, following a period of inactivity, the instrument automatically powers
off after the preset TIMER period.
If selected OFF , auto power off is inhibited and once switched on, the instrument remains ON until
it is manually switched OFF .
7.4.6 Calibration
Refer to Section 8 for a full description of the calibration procedures.
SET COMMS SELECT PARAM. SELECT VALUE SET COMMS
DATA RATE
DATA BITS
STOP BITS
PARITY NONE
HANDSHAKE NONE
DATA RATE
DATA BITS
STOP BITS
PARITY NONE
HANDSHAKE NONE
SELECT OPTION
POWERDOWN
POWERDOWN SELECT PERIOD
SELECT VALUE
POWERDOWN
POWERDOWN
CHANGE
VALUE
CHANGE
VALUE
CHANGE
VALUE
CHANGE
VALUE
TIMEOUT = 10 Seconds
INSTRUMENT WILL TURN
OFF AFTER TIMEOUT
PERIOD OF INACTIVITY.
ONLY VALID IN TIMER
MODE OF OPERATION
TIMEOUT = 10 Seconds
INSTRUMENT WILL TURN
OFF AFTER TIMEOUT
PERIOD OF INACTIVITY.
ONLY VALID IN TIMER
MODE OF OPERATION
TIMEOUT = 10 Seconds
INSTRUMENT WILL TURN
OFF AFTER TIMEOUT
PERIOD OF INACTIVITY.
ONLY VALID IN TIMER
MODE OF OPERATION
TIMEOUT =
INSTRUMENT WILL TURN
OFF AFTER TIMEOUT
PERIOD OF INACTIVITY.
ONLY VALID IN TIMER
MODE OF OPERATION
TIMEOUT MODE
TIMER
TIMEOUT MODE
OFF
TIMEOUT MODE
TIMER
TIMEOUT MODE
TIMER