172
8.1 T
YPES
OF
STATUS
MESSAGES
ALS
20X
256
5140
Rewinder control
Rewinder control
During problem-free operation,
the rewind unit dancer arm only
moves a minimal distance
around the "control position".
This is the position the dancer
arm takes up after initialisation
of the machine.
– Any force applied that moves the
dancer arm from its control position.
Example: The feed motor is blocked;
the backing paper is not conveyed
quickly enough; as a result the
dancer arm is pulled upwards.
Example: The backing paper is torn;
the dancer arm springs downwards.
Press the
key.
– This reinitialises the dancer arm con-
trol; the dancer arm moves back into
the control position.
5142
Dancer home pos. Homeposition of the rewinder dancer
arm could not be found.
Check, if the sensor board of the dan-
cer arm is connected properly.
Replace the sensor board.
5143
Rewinder Stop
– This message appears when the
dancer arm was held against its up-
per stop for more than two seconds.
Effect:
Power to the rewinder motor is
switched off, so that the rewinder can
be turned easily by hand.
This effect is helpful when in-
stalling a new label roll, because
the rewinder can be turned
easily.
Press the
key to confirm the er-
ror message.
5144
Rewinder Init
The message has a couple of possible
causes:
– No label material inserted.
– Rewinder sensors are not or not pro-
perly connected.
– Sensor board position is faulty.
– Sensor defective.
Insert material.
Check the connection. Connect the
sensors properly.
Correct the position of the sensor
board.
Exchange the sensor board.
Status Status text
Cause
Action to take
[196] List of error messages
Summary of Contents for ALS 204
Page 1: ...ALS 204 206 256 SERVICE INSTALLATION MANUAL Labeller Edition 8 3 2012 Original version ...
Page 2: ......
Page 223: ......
