To specify connector groupings from the Virtual Matrix view:
1. From the Edit menu, choose Manage Virtual Matrix Groupings.
The Manage Virtual Matrix Groupings dialog box appears.
2. Click the Group by Pattern button to assign sequential or spanning
groupings of signals for connectors (see page 8-10).
Or
Click the Assign Individually button to assign signals to connectors
one at a time (see page 8-11).
After entering information in the newly opened window and clicking
OK, the Manage Virtual Matrix Groupings dialog box will reappear
with the results displayed in the read-only box at the bottom (see
graphic above). The tabs allow viewing of each channel of grouped
signals for both sources and destinations.
3. Repeat as needed, using either method to assign additional
groupings.
Note:
At any time, click the Accept Groupings button (at the bottom of
the box) to save the groupings to the virtual matrix or click the Cancel
button to start over. Remember, however, that the new groupings are not
implemented until the modified configuration file is downloaded (see
Section 8.4) to the system.
Installation and Setup Guide
8-9
Modifying Groupings
Configuration
Files
