Executing Switches
Switches connect an input signal from a source device to an output
signal(s) that goes to your destination device(s). The signals connected in
a switch command are groups of individual signals coming through the
connectors on the rear of an enclosure. When executing a switch, you
must specify a level that has all the signals you want to route. Level
definitions reside in the configuration information in each enclosure’s
CPU.
You can enter execute switch commands from the following:
ä
CP-10 Control Panel
ä
CP-10 Remote Control Panel
ä
An external serial controller (computer, AMX, Crestron, etc.)*
via BCS (Basic Control Structure) commands
ä
An SBC (Single Bus Controller)
The CP-10 Remote Control Panel works the same as an attached control
panel. SBCs are not covered in this manual.
*AutoPatch provides, at no charge, an interface library for various
controllers. This library is called the X
N
Net Communication Library.
This library, documentation, and programming examples are available
upon request from your AutoPatch representative.
Operation Manual
2-1
