2.1 Executing Switches
Using the CP-10 Control Panel
You can execute switches from the CP-10 Control Panel by using the
steps below or by executing a local preset. For information about local
presets, see Chapter 4, “Executing Local Presets.” BCS (Basic Control
Structure) commands can also be used to execute switches (see page
2-5).
The following example switches Input 2 to Output 3 on Level 0.
You can return to the Command screen at any time by pressing the
Cancel key.
Note:
In each switch command, you can enter multiple output signals,
but only one input signal and only one level.
To execute a switch using the CP-10 Control Panel:
1. At the Command screen, press the Change key.
The Change screen appears.
2-2
Operation Manual
Executing Switches
