Verifying Signal Status
Verify the status of a signal to confirm that the switch has executed
properly.
You can enter commands to verify signal status from the following:
ä
CP-10 Control Panel
ä
CP-10 Remote Control Panel
ä
An external serial controller (computer, AMX, Crestron, etc.)*
via BCS (Basic Control Structure) commands
ä
An SBC (Single Bus Controller)
The CP-10 Remote Control Panel works the same as an attached control
panel. SBCs are not covered in this manual.
*AutoPatch provides, at no charge, an interface library for various
controllers. This library is called the X
N
Net Communication Library.
This library, documentation, and programming examples are available
upon request from your AutoPatch representative.
Operation Manual
3-1
