Disconnecting Switches
Disconnecting a switch removes an input signal from one or more output
devices. You can disconnect a single switch on one level with one
command; however, you cannot disconnect all signals on a single level
with one command.
You can disconnect switches only from the following:
ä
An external serial controller (computer, AMX, Crestron, etc.)*
via BCS (Basic Control Structure) commands
ä
An SBC (Single Bus Controller)
SBCs are not covered in this manual.
*AutoPatch provides at no charge, an interface library for various
controllers. This library is called the X
N
Net Communication Library.
This library, documentation, and programming examples are available
upon request from your AutoPatch representative.
Operation Manual
5-1
