4.1 Attaching Input and Output Cables
When attaching input and output signal cables, refer to the sheet labeled
"AutoPatch 8Y-XL Connector and Groupings Guide" that was included
in the shipping box(es). The sheet shows you where to attach each signal
cable on the rear of each enclosure.
Follow the sheet exactly; the system
was programmed at the factory to operate only as indicated on the sheet.
Note
:
Before connecting all signal cables, attach only the first two
inputs and outputs from the "AutoPatch 8Y-XL Connector and
Groupings Guide," and then perform a test switch to verify that the
system is working properly. See Chapter 7 for details on performing a
test switch.
To attach video inputs and outputs,
slide the video cable onto the input
or output connector (see graphic below).
Make sure video signals are attached to video connectors and sync
signals are attached to sync connectors. The connectors look identical,
but the “Connector and Groupings Guide” identifies them.
4-2
Installation and Setup Guide
Attaching Inputs and Outputs
33
34
35
36
37
39
38
40
42
41
43
44
46
48
45
47
57
58
59
60
61
62
63
64
51
49
50
52
56
55
53
54
Attach a video cable to a BNC connector
Inputs
and
Outputs
