ATEN VK0100, User Manual, Page: 69 / 302

Chapter 2. Hardware Setup and Panel Oper
-
53
VK112MK
Š Directly into the chosen surface
a) Refer to the Panel Mount Cutout diagram ( CAD and Panel Cutout
Diagrams , page 265) to find out the length and width of the cutout area
and mark the opening on the chosen surface.
b) Cut out the marked area to a depth of at least 6 cm (2.36 inches).
2. Pair the Keypad with a Control Box by adjusting the Keypad ID Switch
(blue) to the ID number that the Control Box uses.
Note: One ATEN Control Box can work with up to 8 Keypads.
3. Supply the Keypad with power and network connectivity using one of the
following methods. The LAN LED light green to indicate that the Keypad
is supplied with power and successfully linked to the network.
Š To power the Keypad by PoE, use an Ethernet cable to connect the
Keypad to a PoE-enabled Ethernet switch.
Š
If you do not have a power sourcing equipment, use an Ethernet cable
to connect the Keypad to LAN and a power adapter to supply power.
Š Purchase a power adapter for this installation.
Š
Follow the steps below to prepare the power adapter and then plug
it to the Keypad.