ATEN VK0100, User Manual, Page: 44 / 302

ATEN Control System User Manual
28
IR / Serial
These two or four (VK1100 / VK2100) ports can be configured to connect IR
and RS-232 devices. By default the ports are set to transmit IR signals. Use the
ATEN Configurator software to configure the ports for RS-232 signals. The
diagram below shows ports on the VK2100. The VK1100 is the same except
that it has fewer terminals blocks and the Uni-directional setting is (0 to 5 V).
IR Connection: Connect a transmitter cable to the IR and Ground ports on the
Control Box and install the IR transmitter on or near the device's IR receiving
port, as shown on page 29.
Serial Connection: Connect the device's receiver (RX) and ground ports to the
Serial (TX) and Ground ports on the Control Box. Next configure the same
serial port setting on the Control Box and serial device so that they can
communicate.
Uni-directional (+ -5 V)
Baud Rate: 300 to 115200
(default: 9600)
Data Bit: 8 (default) or 7
Stop Bit: 1 (default) or 2
Parity: None (default), Even or
Odd
IR: Blu-ray / DVD Player, TV,
Audio Receiver, Projector, etc.
RS-232: Camera, Projector,
Switch, Audio Mixer, Multimedia
Device, etc.
Connects to
4 x RS-232 Ports
TTL Level (0 to 5 V)
Carrier Frequency:
10kHz~455kHz
4 x IR Ports
or
VK2100