ATEN VK0100, User Manual, Page: 159 / 302

Chapter 4. ATEN Configurator (VK6000)
143
Double-click the Change Label command to type the warning message
you wish to display when the speaker volume reaches 10 db.
Š Feedback conditions – Use feedback conditions for the controller to
carry out actions (commands) when the specified feedback value meets
the specified conditions. Use
Feedback If , Feedback Else If , and/or
Feedback Else to fully cover all scenarios in your application.
Note: The Else If and Else conditions can only be nested under the If
conditions and can not be used on their own.
Š
Change Button State – this command changes the image of another
button when this button is pressed – allowing the image of any other
button to change when the command from this button is sent. Change
Button State is added to the end of the Commands lists. When adding this
to a
Toggle button it allows the image to switch with the toggle behavior:
Normal or Pressed . In this situation the Change Button State is added to
the end of both the Toggle ON and Toggle OFF Commands lists.
Š Change Label – this option changes a label’s text with text that you enter
manually or with text from a device’s return message. A Manual Change
Label can be added to the beginning or end and with a Condition in the
Commands list. Adding it to a Condition guarantees the label only changes
when the command initiates.
Š
Change Group Button State – this option adds a command that changes
the button selected in a Radio Group (page 85). Create a Radio Group
and then a Function will be listed for it when Change Group Button State
is selected. Add the Change Group Button State to the Commands list of a
button and use the drop-down menu to select the button in the Radio
Group you want selected.
Š
Change Slider Bar Level – this option adds a command that changes the
level of a Slider Bar . Create a Slider Bar and then a Function will be listed
for it when Change Slider Bar Level is selected. Add the Change Slider
Bar Level to the Commands list of a button and use the drop-down menus
to select the Slider Bar and Level to change.
Š Change Button Name – this option adds a command that displays
specified text on another button when this button is tapped. A typical
application of this command is when you want to show the assigned
source on an output device as soon as the source is switched.
Š Function – lists the commands that can be added to the Commands
list. Select an option under Device , then double-click or drag & drop
commands from the Function list to add them to the Commands list.