Manual Weighing Controller A 810
A.S.T. Angewandte SYSTEM-TECHNIK GmbH Dresden
Page
67
3.2. Combination of “Func” and any numeric key
To call one of the following functions press “FUNC” key and after that please press any numeric key.
These functions are dedicated to numeric keys and can not be edited by user. To switch back to weighing
mode press “TARE” key.
3.2.1. Reduced setup (0)
Funtion Call 108: Any parameters that are accessable due to legal-for-trade conditions can be changed.
The “Reduced setup” structure is similar to “setup mode” (refer to 5.3 at page 93).
3.2.2. Show actaul code (1)
Funtion Call 190: This function shows the actual codeset. Refer to 3.2.3.2 for editing parameters of
codeset and what parameters belong to a single codeset.
FUNC
1
UPPER
3.2.3. Activate code / edit codesets (2)
Funtion Call 191: This function allows the operator to select (3.2.3.1) the active one of ten codesets.
Selection of active codeset is done via external input or internal selection (3.2.3.2).
FUNC
2
OVER
3.2.3.1. Code selection
This menu defines the code N°
used in operation, as long the
code source is not switched
to external.
10 different code blocks might
be selected (0 …9)
default setting: 0
3.2.3.2. Code source select
This selection defines whether
the code block N° is used in
selected operation by
external inputs or internal
select (see above).
default setting: off
Note
: Selection of a codeset greater 9 will
generate “Err110”. In case of error active code
is set to 9.
ENT
c o d e S e l
0
/NET
GROSS
0
-1
+1
value
incr. decr.
0
/NET
GROSS
A
c t c o d
0
c o d e E
x
t
o F F E
X
t
o n E
x
t
/NET
GROSS
0
0
/NET
GROSS
ENT
TARE
Summary of Contents for a810
Page 2: ......
