13
12
!
Caution
!
The protective safety earth/ground connection must connect first and disconnect after the
AC line and neutral wires. All approved AC power connectors are designed to meet this
requirement. If the input wires are directly connected to an AC mains circuit assure that
the AC source is deactivated prior to making or disconnecting the connection.
3.8 Fuse
The AC mains fuses installed inside the product are designed to protect the input from major
failures, and should not fail under normal operating conditions. Therefore, any sign of fuse
failure is an indication that other part(s) of the product is damaged. If fuse melting happens,
we recommend that the product be sent back to us for repair.
!
Warning
!
No user serviceable components enclosed. Do not disassemble the power's enclosure/
case to replace the fuse, as there is a danger of sustaining an electric shock.
Products Introduction
3.9 Warm-up Time
Once the power supply is switched on, all features of the unit are operable after the start
routine has completed. However in order to achieve the specified operating accuracy, please
allow the power supply to operate for a warm-up time of 30 minutes.
Panel Description
PROFESSIONAL
INNOVATIVE BRANDING
SERVICE
PROFESSIONAL
INNOVATIVE BRANDING
SERVICE
3.10 Unit Shutdown
When you no longer need to use this product, please make sure the front panel power switch
is set to the “OFF” state. After the AC power is switched off the internal fan will continue to run
for a few seconds to allow the internal capacitors to discharge. When discharging is completed,
the unit will automatically shut down.
3.11 Operation Precautions
1. When the unit is first turned on the DC output is in a deactivated state. It can be activated
by pressing the output turn on push button on the front panel or by remote control command.
2. Before turning on the DC power output, check that all the setting values of the power supply
are in accordance with the load requirements.
3.12 Start Procedure
The power source is turned ON using the power toggle switch located on the left hand side of
the front panel. A splash screen will appear as shown below.
After several seconds, the LCD will display the Diagnostics screen.
The diagnostics will take several seconds to complete. If all results are OK, the unit will revert
to the default main screen.
Please contact APM CS engineer for support if there is any failed item in this self-checking page.
DC Source
Self Checking
Model
Serial NO.
FPGA1 Ver.
FPGA2 Ver.
DSP Ver.
Display Ver.
Remote Ver.
Option Check
Protect Check
Control Check
EEPROM Check
SP80VDC6000W
0166481953000003
V100R100C11
V100R100C08
V100R001C13
V100R001C19
V100R001C06
Ext-I/O NA GPIB/LAN NA
FAN OK Temp OK
1. OK 2. OK 3. OK 4. OK
OK
