Ansul AutoPulse Z-28, Instructions Manual

Page: 108 / 198

Programming a Point’s Software Point Type,
Continued
7-10
Procedure, continued
Category Point Type Application
Control
AHUF AHU OFF Relay (Dual Relay Control)
AHUO AHU ON Relay (Dual Relay Control)
AHUR AHU ON/OFF Relay (Signal Relay control)
ALTERN Alternate Elevator Capture
BSIGNAL Trouble/Supervisory Bell Signal (on until ACK)
DHOLDER Door Holder Control
PRIMARY Primary Elevator Capture
RELAY Generic Relay
RELISIG
Releasing investigation signal (NYC abort
operation).
RELSIG
Suppression release audible signal (Temporal on
first alarm; 120 bpm on hazard alarm (delay timers
active); steady on release; off on silence).
RELVIS
Suppression release visual signal (on when
releasing output activates; off on reset).
RELWVIS
Releasing warning visual circuit (on when alarm
occurs in hazard area; off on reset).
RSIGNAL Alarm Signal (on until reset)
RVISUAL Visual (on until reset)
RWATER Waterflow Signal (on until reset)
SIGNAL Generic Signal (no default operation)
SSIGNAL Alarm Signal (on until silence)
SUPREL Suppression (Agent Discharge) Release Output
SUPV Sprinkler Supervisory Signal (on until ACK)
24 Point I/O
LAMP Lamp Output
OSWITCH 2-position switch (open, supervised)
PIEZO Piezo output
RELAY Generic Relay
RRELAY Relay (on until reset)
SSWITCH 2-position switch (open/short supervised)
TSWITCH 3-position switch (open, supervised)
USWITCH 2-position switch (unsupervised)
Table 7-3. Point Types, continued