Amtech Axpert-Eazy AMT-011-4, Instruction Manual

Page: 39 / 242

Axpert-Eazy AC Variable Frequency Drive
5.1
5
CHAPTER-5: CONTROL INPUT / OUTPUT TERMINALS
5-1 Input / output terminal functions of PCA-2014A (Control Unit)
TB1
TB2
K1
Fault Relay
K2
Prog Relay-1
K3
Prog Relay-2
+
JP3
LD
JP5
NLD
L
D
N
L
D
VIEW OF PCA-2014A
P15 0V VIN
FSV FSI
IIN
0V
VO2
VO1
IO1 CANH RUN PSI6 COM
0V IO2 CANL STOP +24V PSI1 PSI3 PSI5
PSI2 PSI4 +24V PSO1
COM PSO2 PSO4 TX COM PBN PAN COM
PSO3 COM RX PB PA +5V
FA FC FB R1A R1C R1B R2A R2C R2B
JP1
S
O
U
R
C
E
S
IN
K
SYMBOL NAME USE
+24V +24V source This source is used for the Programmable Sequence Inputs. The logic for
the Programmable Sequence Inputs can be changed to sink or source with
the help of
JP1 on the control board.
COM
RUN RUN command This is programmable sequence input and can be configured to different
functions using
C114 .
STOP STOP command This is programmable sequence input and can be configured to different
functions using
C115
.
PSI1-6 Programmable
Sequence Inputs
1 ~ 6 These are programmable sequence inputs and can be configured to
different functions using
C101 ~ C106 .
PSO1-4 Programmable
Sequence
Outputs 1 ~ 4 These are programmable sequence outputs and can be configured to
different functions using
C107 ~ C110 .
P15 +15V source This is a 10V source used when a frequency setter is connected to the
FSV input circuit. The frequency setter to be used should be a variable
resistor of 2k and 2W.
0V Common This is a common terminal for analog input signals.
FSV Frequency
Setting Voltage
input This is mainly used for setting the frequency (speed) input. A maximum
frequency setting is available at 10V input. This setting is valid when FSV
0-10V, FSV 0-5V, FSV 10-0V or FSV 5-0V is selected as frequency
reference input in
A106
or
D204
or torque reference input in
A108
. Also,
this input can be configured as PID Reference input ( C603 ) or PID
Feedback input ( C604 ) or Math Reference Input2 ( A702 ) or Variable bias
( A706 ) for math operation.