Amada RG35S-100, Operator'S Manual, Page: 91 / 110

V-47
Symptom Cause Remedy
Pressure adjusting knob is not
tightened.
Turn it fully clockwise (+).
Rising speed change position is not
properly set.
Set it again as described in “10-1.
Setting rising speed change position”
in this Part.
Oil level in hydraulic oil tank is low.
Add oil as described in “2.
Maintaining hydraulic system” in Part
VI.
Hydraulic pump is faulty. Contact AMADA.
Filters in hydraulic oil tank are
clogged.
Clean or change them as described
in “2. Maintaining hydraulic system”
in Part VI.
Specified
pressure is not
delivered.
Seal in cylinder is worn. Contact AMADA.
Multiple opening limit is not properly
set.
Set it again as described in “10-2.
Setting multiple opening limit” in this
Part.
Multiple opening
limit of ram
cannot be set.
Multiple opening limit setting lever is
faulty.
Contact AMADA.
Multiple closing
limit of ram
cannot be set.
Handwheel lock knob was
overloosened so that multiple closing
limit setting handwheel became
faulty.
1 Remove handwheel lock knob.
2 Expand internal pin with scriber or
other sharp-pointed tool.
3 Reinstall handwheel lock knob as
shown below. If you are unable
to remedy trouble, contact
AMADA.
NORMAL FAULTY
PIN LOCK KNOB
LOCK KNOB OVERLOOSENED
SCRIBER
EXPAND INTERNAL PIN WITH SCRIBER
OR OTHER SHARP-POINTED TOOL