Amada RG35S-100, Operator'S Manual, Page: 4 / 110

iv
Part V Operation ............................................................................ V-1
1. Inspection before start of day’s work ..................................... V-3
2. Preparing for operation.......................................................... V-3
3. Turning on power................................................................... V-5
4. Removing tools ...................................................................... V-6
4-1. Preparing for removing tools........................................... V-6
4-2. Removing punches ......................................................... V-8
4-3. Removing dies ................................................................ V-9
5. Installing tools ....................................................................... V-11
5-1. Preparing for installing tools .......................................... V-11
5-2. Installing dies ................................................................. V-12
5-3. Installing punches .......................................................... V-14
6. Preparing for special bending............................................... V-16
6-1. Installing and removing punch holders .......................... V-16
6-1-1. Removing punch holders ........................................ V-16
6-1-2. Installing punch holders .......................................... V-17
6-2. Installing punches rearside front.................................... V-18
6-3. Installing wide dies......................................................... V-19
7. Other uses ............................................................................ V-20
7-1. Adjusting punch holders................................................. V-20
7-2. Using one-touch punch holders (option)........................ V-23
7-2-1. Installing and removing punches from front ............ V-25
7-2-2. Installing and removing punches by sliding them
along groove of rear clamping plates .....................
V-28
7-2-3. Installing and removing rear clamping plates.......... V-29
8. Aligning tools ........................................................................ V-32
8-1. RG35S ........................................................................... V-32
8-2. RG50, RG80, and RG100.............................................. V-34
9. Setting tool origin .................................................................. V-37
10. Bending operation............................................................... V-38
10-1. Setting rising speed change position ........................... V-38
10-2. Setting multiple opening limit ....................................... V-39
10-3. Bending worksheet ...................................................... V-40
10-3-1. Temporarily setting multiple closing limit............... V-40
10-3-2. Setting worksheet.................................................. V-41
10-3-3. Setting bend angle ................................................ V-42
11. Turning off power ................................................................ V-44
12. Troubleshooting .................................................................. V-46
13. Clearing emergency stop condition .................................... V-48