Amada RG35S-100, Operator'S Manual, Page: 60 / 110

V-16
6. PREPARING FOR SPECIAL BENDING
6-1. Installing and removing punch holders
When special-shaped punches are used or when a worksheet comes
into contact with punch holders during bending, the punch holders may
be removed from the upper beam for bending the worksheet. Install
and remove the punch holders as described below.
6-1-1. REMOVING PUNCH HOLDERS
1 Remove the punches from the punch holders. (Refer to “4.
Removing tools” in this Part.)
2 Turn the POWER
ON/OFF keyswitch to
OFF, and remove the
key from the
keyswitch.
3 Turn up the multiple
opening limit setting
lever to clear the
multiple opening limit
of the ram.
The ram opens to the
maximum opening
limit.
4 Loosen the clamping
bolts of each punch
holder while
supporting the punch
holder with the other
hand, and remove the
punch holder.
CLAMPING BOLTS
PUNCH
HOLDER