Amada RG35S-100, Operator'S Manual, Page: 76 / 110

V-32
8. ALIGNING TOOLS
WARNING
O
Never put your hand or hands between the
punches and dies.
O
Apply to the installed tools a pressure that
is not higher than the allowable tonnage
marked on them. Unless a proper
pressure is applied to them, the tools may
break and scatter in a dangerous manner.
After installing the tools, align them as described below.
When you reinstall the dies after removing them together with the die
holders, align them again.
8-1. RG35S
1 Turn the POWER ON/OFF
keyswitch to ON.
2 Press the HYD. ON button.
The button illuminates, and the
hydraulic pump motor starts.
3 Clear the pedal stopper, and
fully press the bar pedal.
The ram closes to the multiple
closing limit and stops.
CLEARANCE