Amada RG35S-100, Operator'S Manual, Page: 85 / 110

V-41
10-3-2. SETTING WORKSHEET
WARNING
O
Do not adjust the stoppers by reaching
from the front of the machine. Adjust the
stoppers from the rear of the machine.
NOTE
O
For the operation of the optional backgauge, refer to its operator’s manual.
1 Release the bar pedal.
The ram opens to the multiple opening limit and stops.
2 Loosen the lock bolts
on the top of the
stoppers, and move
the stoppers back and
forth to set them to
the bend width.
ADJUSTING
KNOB
LOCK BOLT
STOPPER
3 Loosen the lock bolts of the supporters, and set the supporters to
the worksheet bend length.
4 Place the worksheet on the installed dies, and push it against the
stoppers while aligning its center in the left/right direction
approximately with the center of the ram.
NOTE
O
When an uneven load is imposed on the left or right side of the ram and
the resultant pressure exceeds the tolerance value, the uneven load
prevention device operates and stops the machine. When bending a
worksheet, set it so that its center in the left/right direction is
approximately aligned with the center of the ram.
O
When the uneven load prevention device has operated and stopped the
machine, release the bar pedal, to open the ram and clear the operation
of the uneven load prevention device. When the HYD. ON button is
then pressed and illuminated, the machine can resume its operation.
5 Go to “10-3-3. Setting bend angle” on the next page.