Amada RG35S-100, Operator'S Manual, Page: 64 / 110

V-20
7. OTHER USES
7-1. Adjusting punch holders
If the worksheet is not bent to a uniform angle along the entire bend
length, adjust the punch holders as described below.
Before adjusting the punch
holder, record the current
value of the scale marked
on the wedge. This value
serves as a guide when
returning the punch holder
to the original state.
1 Loosen the wedge
fixing bolt by about a
half turn with an Allen
wrench.
2 Loosen either of the
left and right clamping
bolts by about a half
turn with an Allen
wrench, and lightly
tighten it again.
CAUTION
O
If both of the two clamping bolts are
loosened, the punch holder falls. Be
sure to loosen only either of them.