Amada RG35S-100, Operator'S Manual, Page: 86 / 110

V-42
10-3-3. SETTING BEND ANGLE
NOTE
O
For the pressure required for a normal bending operation, refer to the bending
pressure chart affixed to the machine.
1 While holding the set worksheet
with both hands, clear the pedal
stopper, and fully press the bar
pedal to close the ram to the
temporarily set multiple closing
limit.
The punches contact and hold
the worksheet.
NOTE
O
When bending the worksheet along a scribed line, adjust the degree of
pressing the bar pedal to stop the ram before the punches contact the
worksheet, and align the punch nose line with the scribed line.
2 With the bar pedal fully pressed, loosen the handwheel to unlock
the multiple closing limit setting handwheel.
3 With the bar pedal fully
pressed, slowly turn the
multiple closing limit setting
handwheel clockwise until the
worksheet is bent to the desired
angle.
4 With the bar pedal fully pressed, tighten the handwheel lock knob
to lock the multiple closing limit setting handwheel.
5 Hold the worksheet with both
hands, and release the bar
pedal.
The ram opens to the multiple
opening limit and stops.