Amada RG35S-100, Operator'S Manual, Page: 35 / 110

III-7
Levelness in front-back direction
Place a stretch bar (or die holder) on the two leveling pins inside each of
the left and right frames of the machine.
Insert a thickness gauge between the front or rear leveling pin and the
stretch bar.
The thickness of the thickness gauge to be inserted is marked at the
front left or right of the ram.
The position where to insert the thickness gauge depends on the
position of the mark on the lower beam as shown below.
When the mark is placed at the upper front of the ram, insert the
thickness gauge between the front leveling pin and the stretch bar.
When the mark is placed at the lower front of the ram, insert the
thickness gauge between the rear leveling pin and the stretch bar.
Leveling machine
Place a spirit level on each stretch bar (or die holder).
Adjust the level of the machine to within 0.05 mm/m {0.0006 in./ft} in the
front-back and left-right directions by turning the leveling bolts at the four
corners of the machine.